![]() ![]() ![]() More About the Single Element Creeping Wave Transducer This technique continues to grow in popularity because of simplicity and because it can provide both detection and preliminary sizing information about the suspected flaw. Further evaluation of signal amplitude, rise and fall time, echo dynamic and pulse duration, hopefully will help determine if the suspect signal is from ID geometry, counter bore, root, or if itĪnother method that can be used for the qualification process involves the use of a single element creeping wave transducer. This initial process usually involves the use of the same 1.5, 2.25, or 5MHz shear wave angle beam transducer that was used in the detection phases. Once a suspected Inner-Diameter (ID) connected crack has been detected by general code or regulatory mandates, it then must be qualified. In general, these techniques have found application for the detection, characterization and sizing of intergranular or transgranular stress corrosion cracks and fatigue-type cracks whether inherent, processing or service induced. This paper provides a brief summary of advanced detection and sizing techniques for the evaluation of flaws connected to the inner surface of test material. ![]() ![]() OEM Microscope Components for Integration.Semiconductor & Flat Panel Display Inspection Microscopes ▾.Aerospace/Wind Blade Inspection Scanners.Flaw Detectors / Phased Array Flaw Detectors ▾.Thickness and Flaw Inspection Solutions ▾. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |